Hi guys,

First of all thanks for contributing to this forum as it means a lot to a great deal of people.

I have a weird issue with my G3 kiosks,

I've been running 5.2 for some time and I wanted to upgrade to 1.2, 1.5, 2.0 and all of them come up with an error. When the installation of 1.2 starts and when it finishes with the first cd it comes up with 1334 error, meaning i can't access cd no. 2 ?!?!?!?
(Cd's are in perfect condition so the problem is not with the actual reading of data)

And when I try the 1.5 and 2.0 version it asks for some initialization cd that I don't have.

Can some one come up with some solution as I'm out of ideas.

Thanks...

Have you de preinstalation CD for the 1.X or 2.X ?
After the recovery ,install the préinstalation CD and after the software program ,all are be well like that!!!
If you dont have the cd initialisation ,load the program are not possible !!!
frenchman

Doi what frenchman says: If you have the original version 1.5 pack there must be included the version 1.5 initial CD. I recommend to recover your system then put the initial CD and then load the software. From version 2.2 on you'll need the version 2.1 initial CD.
Without this initial CD you cannot load software for example from a USB stick but it does more things like some patches for Windows XP or 2000.

I've managed to find the init. cd v1.5 and the installation worked out ok but now a new problems up with the enablement. I've got a dls eneblment cd which is ment for a noritsu running dls but we've bought a frontier and I need the enablement for hotfolders option or Fuji frontier enablement.

Could anybody mail me this since the local distibutor is clueless what I'm talking about.

Thanks for the info!

I have done a cool clone of a machine(g3)which I am now able to load that software containing 2.0 sp1 and I can do this on any g3's..it works. instead of doing the whole loading of software which can take hours this only takes no more than 10 minutes.

have u tried getting into the diagnostic menu/ system diagnostic.. and inside there are options for enablers?

btw: i find v2.0+ slow on g3's..

If you are running V2 on a G3 you must increase the RAM to a minimum of 1GB, preferably 2GB

The v2.0 works fine but I'm missing the frontier enabler in order to connect it to the minilab. Does anybody have that enabler? I've got the one for noritsu dls and non-dls but nothing else.

Cheers.

Go to the setup menu/diagnostic/services diagnostic/pass 789632/activation tool for kiosk/select the fuji frontier enabler and install/

Be sure before ,any other enabler for minilab are actived !!!! if it's the case , unistal the enabler with tool for desactivation !!!

good luck frenchman

Spot on! That's great information.

I've managed to do it with in 5 min from seeing your post

Thank you again,

Cheers!