Jump to content
  • advertisement_alt
  • advertisement_alt
  • advertisement_alt

edias

Members
  • Content Count

    5
  • Joined

  • Last visited

About edias

  • Rank
    NooB

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

  1. Hi Alansur! I use it stand alone.
  2. Thank you! And where would I be able to get the installation software?
  3. edias

    X-4299 Error Sp3000

    Hi Minilab service! I have the same error with the toshiba of an SP3000 after a new software install, could you please tell me what settings were changed? Thanks a lot!! Edgar
  4. edias

    X-4299 Error Sp3000

    Hi Minilab service! I have the same error with the toshiba of an SP3000 after a new software install, could you please tell me what settings were changed? Thanks a lot!! Edgar
  5. Hi everyone, I own a Fuji Frontier SP3000 and wanted to upgrade the software, so I've cloned the Hard Drives from a friend, one for the scanner PC (toshiba) and another for the PIC software. At my friend's SP3000 both machines connect with each other, as well as with the scanner, just fine. On my install both machines boot, all drivers are properly installed and I can ping both machines, this means the PCs are communicating fine with each other. But the scanner PC (the toshiba) when booting, the fuji software gives me 1st the X-4299 error and after that the E-4213 error (error images attached). As far as i can tell it never comunicates with the scanner, there's no carrier warm-up noise as usual, and the software never fully loads. Hopefully I'm not forgetting any detail, but feel free to ask me any questions. Any ideas would be really appreciated!! Thanks in advance! Edgar
×