• Announcements

    • NeilT

      Mini Lab Help.com For Sale   03/16/2017

      2017 - Minilab Help could face closure at the end of the year. Our outgoing running cost and time is no longer being covered by our sponsorship. 
      With almost 10,000 members we have grown to be perhaps the worlds largest forum for Mini Lab Help. 
      We would now consider the sale of this web site, please contact us if you wish to discuss. 

johncord

Members
  • Content count

    96
  • Joined

  • Last visited

  • Days Won

    1

johncord last won the day on December 14 2012

johncord had the most liked content!

About johncord

  • Rank
    Minimum Member
  1. Interested in such software for win7/win as I have the Xp version but its now out of use , would appreciate a reasonable working quote. Thanks
  2. I had qss kids running on xp with qss 32 without fail , I presume it should run smoothly with 3302 and xp
  3. these are faults that all inkjet owners will experience no matter Epson, Fuji etc, there are no equipment that does not fail, the problem is no problem once solved.
  4. Thanks , just for info replaced TRX111 connector yesterday and up to now its working, meanwhile thanks for the response
  5. tried and cleaned connectors 518/517 223/224 222/221 54/53 76/75 stiil no luck cables seem ok, any sugesstion .Last 3 days was taking a long time to respond and today it occurred at startup ? appreciate Thanks
  6. its an intersting link, is it possible to download ?
  7. Thats one good news, hope it stays this way
  8. once on an Italian Magazine I had read that the EU licence will be like a Pass for the EU , in other words it was intended that even the Photos would be taken by either the Police dept or the Passport office or like, in other words another stake of flesh taken away from the photo market.. I hope and wish that I am wrong.
  9. is it only when making test calibration?
  10. I think its low chemistry utilization , either replace part of the Tank dev .
  11. I think that DRY is the future to stay !
  12. If the 3011 have got arcnet /fiber optic cables , then i would check those throughly, !
  13. To correct and amend just noticed that when i made the arcnet test i was listing the 32xx not the 32xxsd i redone the arcnet test closing Noritsu programm and got the screen test attached . I have tried to blow away the dust from the sockets of the arcnet, but i did not trim any cables as stated above , is there a way to clean the fiber tip. arcnetm.bmp
  14. Follow up, Initializing takes approx 4 minutes, While Printing 50 prints . I got arcnet error 6901-0201 , stopping the alarm got a second error 6901-0201, stopping the alarm got the third error 6074-0008 B Laser . any ideas ?? Thanks Arcnet cables seem clean unfortunately i have not got a arcnet cable cutter.