Jump to content
Sign in to follow this  
tobeythorn

Pakon F135 Plus Error 149

Recommended Posts

Hi,

I just purchased a used Pakon F135 Plus film scanner. Using VMWare Fusion on my Mac Mini, I setup a Windows XP virtual machine with an additional unformatted "N" partition. and installed the PSI 3.0 software. The scanner is recognized, and I can begin a scan using the PSI software. However, the scan stops after about 2 inches and alerts me of error code 149. When I click OK, and window asking for an "Index" for DX codes comes up, and I can see previews for a few "frames" consisting of the exposed first few inches of my roll of film before the DX codes start. The film is Kodak Portra NC 400, which has DX codes on it. Can't find any info about this. I ran the track test and gain test in the calibration wizard, but it didn't indicate whether it was successful. You help is much appreciated.

-Tobey

Share this post


Link to post
Share on other sites

If it helps,

Here is the relevant bit from the error log.

---- Thu May 24 11:39:45 2012 (Version 3, 1, 0, 28) ---- (Scanner Type 1351, Serial 16238) ----

Version USB 0x03,0x0F  CCD 0x00,0x00  Lamp 0x05,0x0A  DX 0x00,0x00  Motor 0x05,0x06  Aps 0x00,0x00

CN_Global FN_uiGetScanLines EC_ProcessedRingTailOverflow (149) 0

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
Sign in to follow this  

×
×
  • Create New...