pepe21 3 Report post Posted March 24, 2016 I have a Fuji 5700 and trying to set up with MS01 and it connects but when I try to access the menu on printer it gives me DNS NOT FOUND, I've done this before and I know the IP on the firmware has to be 192.168.0.10 but perhaps the Ip on printer is wrong...anybody else with this problem? Quote Share this post Link to post Share on other sites
pepe21 3 Report post Posted March 24, 2016 ******SOLVED******* Quote Share this post Link to post Share on other sites
barsheed 9 Report post Posted March 24, 2016 Good Quote Share this post Link to post Share on other sites
Trev Taylor 17 Report post Posted March 25, 2016 You found the menu on the printer then.....hehehe. Quote Share this post Link to post Share on other sites
adem 1 Report post Posted April 28, 2016 I have a Fuji 5700 and trying to set up with MS01 and it connects but when I try to access the menu on printer it gives me DNS NOT FOUND, I've done this before and I know the IP on the firmware has to be 192.168.0.10 but perhaps the Ip on printer is wrong...anybody else with this problem? please i have a problem into frontier 550 not booting he see just frontier ...(3point) you can help me please i think GMD 23 it's possible help meee Quote Share this post Link to post Share on other sites
Jesus Bautista 0 Report post Posted February 8 El 24/3/2016 a las 12:15, pepe21 dijo: ****** RESUELTO ******* Disculpa. Como lo corregiste Quote Share this post Link to post Share on other sites
Minilab service 249 Report post Posted February 8 Nesupratau, ko klausi, bet viskas parašyta. Paskaityk šiek tiek aukščiau. 1 Forestyl reacted to this Quote Share this post Link to post Share on other sites
Jesus Bautista 0 Report post Posted February 8 Kaip ištaisėte problema? Quote Share this post Link to post Share on other sites
Minilab service 249 Report post Posted February 8 Please write in English, because your messages in some unknown language will be ignored. First on minilab keyboard menu need to access network setting menu. Look IP and mask there. On Windows network settings need correctly adjust firewire network card ( IP and mask ) . From computer run ping to minilab - start and run ping 192.168.x.x - t ( instead x - your minilab IP address ) . You should have connectivity and shouldn't be errors. If have not connection - check firewire cable, firewire board on FMPC ( or scanner, if have tethered printer ) and firewire board on printer ( it is the same ) . If all they are working - check Windows settings ( firewall, UAC, sharing options ) . Try to ping from other computer ( do not need Fuji software - only driver ) . When you check all that can advice something else, 1 Forestyl reacted to this Quote Share this post Link to post Share on other sites
