QualexTech 1 Report post Posted November 16, 2019 Hi Folks, I have been using my Kodak 6800 and 6850 for photobooths and everything works ok but I was wondering if there is a way to program the cutter to cut the prints into 2x6's instead of 4x6's ? Right now we have a 4x6 template set up to print 2-2x6 strips on the 4x6 canvas and it works just fine except that we have to cut every print in half after the print is done. I can imagine that it would need a few lines of code in cutter driver etc. to accomplish this or is it too much and too deep under the hood ??? your insights is greatly appreciated. Sample photo attached. Rick Quote Share this post Link to post Share on other sites
marijo 7 Report post Posted January 13, 2020 https://imaging.kodakalaris.com/retailers/retailers-support-downloads Quote Share this post Link to post Share on other sites
QualexTech 1 Report post Posted January 13, 2020 there is nothing in that link that will do what I asked for thank you anyways. Quote Share this post Link to post Share on other sites
QualexTech 1 Report post Posted January 14, 2020 Look at that, you were right !!! The problem is it needs newer operating system on the PC, but at least there is a way ! Thank you ! Quote Share this post Link to post Share on other sites