yokololo123 1 Report post Posted February 10 any advice? Quote Share this post Link to post Share on other sites
Minilab service 249 Report post Posted February 10 If you have message 05912-0000 then something wrong with your CD replenishment. 05912-0000 means predetermined process amount was exceeded. Your minilab printed photo to have empty replenishment tank, but chemicals remain there. Check replenishment rates on processor setting menu. Pay attention - rates for CP-49E, CP-49HV and CP-49LR are different. Also check and calibrate and replenishment pumps. Maybe CD pump doesn't work properly. After that go to service mode ( password 2260 ) , install new cartridge and make initial replenishment procedure. After that error disappear and you can print. Quote Share this post Link to post Share on other sites
yokololo123 1 Report post Posted February 10 15 minutes ago, Minilab service said: If you have message 05912-0000 then something wrong with your CD replenishment. 05912-0000 means predetermined process amount was exceeded. Your minilab printed photo to have empty replenishment tank, but chemicals remain there. Check replenishment rates on processor setting menu. Pay attention - rates for CP-49E, CP-49HV and CP-49LR are different. Also check and calibrate and replenishment pumps. Maybe CD pump doesn't work properly. After that go to service mode ( password 2260 ) , install new cartridge and make initial replenishment procedure. After that error disappear and you can print. It appeared right after it did a chemical mix.. And thanks! Quote Share this post Link to post Share on other sites
Minilab service 249 Report post Posted February 10 To fix error need to do make initial replenishment procedure from service menu ( not just fill chemicals ) .Check level sensors. Maybe one, or few doesn't work properly. Also check replenishment rates and calibrate replenishment pumps. Quote Share this post Link to post Share on other sites
