safee12 Posted February 29, 2012 Report Share Posted February 29, 2012 hey guyz please help me out . my machine DKS 1530 lamp burnout. i changed to to bulb but still its saying lamp burnout. so can you please help me with this issue. i tried few bulbs nothing works. Quote Link to comment Share on other sites More sharing options...
jorm Posted March 1, 2012 Report Share Posted March 1, 2012 Hi I would change the lamp socket as well. jorm Quote Link to comment Share on other sites More sharing options...
PHOTOLABPART.COM Posted March 1, 2012 Report Share Posted March 1, 2012 Check with Power Supply Interchange with Down side of Dev Tank and Other same is a down side of Exposure lamp house side Pls interchange and check if Lamp is start and processor not working its power supply failear if you want any parts of 1530 Please feel free contact us by PM Thanks Quote Link to comment Share on other sites More sharing options...
pskaro Posted March 1, 2012 Report Share Posted March 1, 2012 Also check the 10A fuse which is up from the lamp power supply. Also try to disconnect the small connector with two wire which is on the lamp power supply near the output wires that command the output ON/OFF of the lamp power supply, with that operation output voltage will always give the set voltage. I had one case where this worked and on the end I switched the position of two 24V power supply's as the other one does not need this command and its output is always ON, but do not forget to adjust the voltages from 24V to 20.5V (actually 19.5V near lamp) and from 20.5V to 24V Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.