Gopo Posted May 7, 2012 Report Share Posted May 7, 2012 The Undefined Error Message keeps reappearing in my 370 even though I've checked the whole machine. Will someone please help me solve this problem? Quote Link to comment Share on other sites More sharing options...
sisir Posted May 8, 2012 Report Share Posted May 8, 2012 Distribution Pad is missing the paper. Check the distribution pad and clean it. Quote Link to comment Share on other sites More sharing options...
Gopo Posted May 10, 2012 Author Report Share Posted May 10, 2012 I cleaned the distribution pad, changed the PDC20, CTL20, DISTRIBUTION SECTOR, AND THE THE PUMP but still after few prints the X102 undefined error reappeared. On the printer there is a message, "paper jam at no. 6". Please any suggestions. Quote Link to comment Share on other sites More sharing options...
Minilab service Posted May 10, 2012 Report Share Posted May 10, 2012 Hi. I had paper jam at no. 6 on 350. Check chain ( 325FA205212 ), sprocket ( 326F0070A ) , gear, spur ( 327F0171A ) and all in this section. Chain can be used from film processor - it's the same or you can buy it from any shop ( not from Fuji ) . All mechanism is hidden under black plastic cover in printer section. It is quit difficult to disassemble it. I had remove AOM driver fans and LDD-20 board to remove this plastic cover. The problem this mechanism supply paper from printer to processor. If print is not transfered from printer to processor in specified time ( sensor at printer exit see it ) you will have this error. This error in my case happened time after time. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.