frontier340 Posted November 18, 2011 Report Share Posted November 18, 2011 hello friends, last month i had a problem with my frontier330, but when i remove the Nozzles it showing in the picture, the prints is ok but there some troubels, my question is : - if i change just the joints does the Nozzles work well or must change Nozzles with joints ??? you Advices is very Important for me Thnaks Quote Link to comment Share on other sites More sharing options...
Magenta Posted November 18, 2011 Report Share Posted November 18, 2011 Just replace the rubber parts, they can stop the turn guide sitting correctly and cause paper jams Quote Link to comment Share on other sites More sharing options...
frontier340 Posted November 18, 2011 Author Report Share Posted November 18, 2011 where is the rubber parts ? Quote Link to comment Share on other sites More sharing options...
Magenta Posted November 18, 2011 Report Share Posted November 18, 2011 the grey and white soft silicon rubber bits can be replaced not the hard plastic Quote Link to comment Share on other sites More sharing options...
photothaibaoui Posted November 19, 2011 Report Share Posted November 19, 2011 do not use the nozeles. desactive autocleaning and wach crossovers evry end of the work ..in the afternon... it s better i have 2 frontier and since 4 years i have no probleme good luuk Quote Link to comment Share on other sites More sharing options...
photothaibaoui Posted November 19, 2011 Report Share Posted November 19, 2011 do not use the nozeles. desactive autocleaning and wach crossovers evry end of the work ..in the afternon... it s better i have 2 frontier and since 4 years i have no probleme good luuk Quote Link to comment Share on other sites More sharing options...
sisir Posted November 20, 2011 Report Share Posted November 20, 2011 Nozzles are used only for autowash the racks, most of the machines in our country are running without nozzles for about 4/5 years. Quote Link to comment Share on other sites More sharing options...
frontier340 Posted November 21, 2011 Author Report Share Posted November 21, 2011 thanks to all can someone tell me the Part# number for this (the grey and white soft silicon rubber bits) see the picture, i dont have the manual serrvices Best Regards Quote Link to comment Share on other sites More sharing options...
nash Posted November 22, 2011 Report Share Posted November 22, 2011 part no. 372F1704D Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.