ahmediraq Posted November 2, 2011 Report Share Posted November 2, 2011 there is aproblem in white region .... the test paper (upkeep) shows yellow insted of white . can any one help me . thanks Quote Link to comment Share on other sites More sharing options...
capital Posted November 2, 2011 Report Share Posted November 2, 2011 seems problem with your chemicals p2 or fog created by laser unit replace the laser unit if your chemicals are ok it will be solved Quote Link to comment Share on other sites More sharing options...
moon Posted November 2, 2011 Report Share Posted November 2, 2011 cheak the laser wire some time there are corban on wire the signal was not going properly if not cheak aom driver or laser Quote Link to comment Share on other sites More sharing options...
PRASANNA PHOTO TEC Posted November 3, 2011 Report Share Posted November 3, 2011 did u check paper feed and check same white? prasanna Quote Link to comment Share on other sites More sharing options...
ahmediraq Posted November 3, 2011 Author Report Share Posted November 3, 2011 yes im check the paper feed and it is white puer ok. Quote Link to comment Share on other sites More sharing options...
PRASANNA PHOTO TEC Posted November 3, 2011 Report Share Posted November 3, 2011 do u have contoll strip holder? if have put un fogy paper pcs, ther run controll strip menu, (preoperation) see white again is the same bad white / check your temp is 38/ all ok please change BL tank Quote Link to comment Share on other sites More sharing options...
PRASANNA PHOTO TEC Posted November 3, 2011 Report Share Posted November 3, 2011 do u have contoll strip holder? if have put un fogy paper pcs, ther run controll strip menu, (preoperation) see white again is the same bad white / check your temp is 38/ all ok please change BL tank also change ps tank Quote Link to comment Share on other sites More sharing options...
Bri Posted November 3, 2011 Report Share Posted November 3, 2011 It is always best to run a control strip to rule out chemistry, however if you dont have any you cant. If your upkeep is yellow in the whites but you paper feed is white then it is not your chemicals it is an exposure/fog issue Quote Link to comment Share on other sites More sharing options...
PRASANNA PHOTO TEC Posted November 3, 2011 Report Share Posted November 3, 2011 if u dont have control srip ( original) you get 5'' paper magazine 16'' lenth paper pcs ( not fogy), and put stip holder , then process if no have stip holder you can try dark your lab and insert DEV rack. then see what happen next is high cost....frist try this before wast more money Quote Link to comment Share on other sites More sharing options...
sisir Posted November 4, 2011 Report Share Posted November 4, 2011 Have you checked the Laser Unit?? Quote Link to comment Share on other sites More sharing options...
yustas Posted November 5, 2011 Report Share Posted November 5, 2011 As I understood you have already checked the chemistry and confirmed that white paper field is white when there is no exposure... Right? Next step is to check AOM driver. I do not know what model of Frontier do you have but some models have 2 channel AOM drivers and some models have 1 channel AOM drivers. Please try to swap AOM drivers ( if you have 1- channel device) and see the result. Or try to swap the cables on 2 -channel AOM driver to see which channel is faulty. Report us the result please. After that we will go further. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.