tech2 Posted September 9, 2011 Report Share Posted September 9, 2011 Anyone had this nightmare? I have swapped out every unit 1 through 5. I have the luxury of doing this because I have access to multiple machines but no luck. changed the PDC-21 and CTL-21 boards-sweet FA The holepunch is operating correctlly. Can't be a motor as every unit has been replaced with another.... regards Tech2 Quote Link to comment Share on other sites More sharing options...
pietre48 Posted September 12, 2011 Report Share Posted September 12, 2011 RFM.Read Fc MANUAL messages and actions.(PP3-C908E)page41 The paper doesn`t reach the D533 within a surtain steps Could be the adjustments of the paper guides or wornouts of them (if you change units you must change the adjustments for that unit) Good luck P. Quote Link to comment Share on other sites More sharing options...
servmanmex Posted September 13, 2011 Report Share Posted September 13, 2011 I had the same problem and solved it by reinstalling the software completely (including windows). I hope it works for you Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.