Binci fotografia Posted July 4, 2011 Report Share Posted July 4, 2011 Hello I have a problem with the Fuji Minilab 340, B-SHG laser is hot, I read on your forum that could do more work without raising revise the PD to 5.8 as I do and as you enter the menu to change these settings, there is a passord. Thanks to all Binci fotografia Italy :-/ Quote Link to comment Share on other sites More sharing options...
manager Posted July 4, 2011 Report Share Posted July 4, 2011 I don't understand what you are asking. The password is miya Quote Link to comment Share on other sites More sharing options...
Binci fotografia Posted July 4, 2011 Author Report Share Posted July 4, 2011 When I enter setup and maintenance with my 7777 I do not see the password screen where you can change and I see absolutely Adjustment parameters to perform the B-SHG screen input / output check thanks Quote Link to comment Share on other sites More sharing options...
yustas Posted July 4, 2011 Report Share Posted July 4, 2011 Dear Binci fotografia Italy Please note that the interference into a service menu without a proper knowledge may cause severe damage to the laser unit. You blue laser is about to die. You would better think about quality repair than use any passwords and change settings in the menu. I am serious here... A lot of our customers destroyed their laser heads by doing this. Quote Link to comment Share on other sites More sharing options...
Binci fotografia Posted July 5, 2011 Author Report Share Posted July 5, 2011 For now I downgraded the pd of 5.8 as did Manager, and the machine is working very well, I know this will not last long but for the moment that's fine, thank you all for the advice. Sincerely Binci photography Italy Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.