PP-48L (cartridge System) for Frontier355

[Husnain147]

Hello Every One!

i have a Frontier355/LP1500Sc

now we start using Replenishment system (PP48-L)

so the Problem with us is...

when LP ask for a R-Cartridge we install the New Cartridge but after this error accrue

"Mixing fails" or " Number of Print exceeded Stop Printing"

then we have to Drain all Replenisher from Tanks, Restart the LP-1500 and FMPC also and after restart install a new Cartridge . after this Lp1500 works good n nice

plz give us some solution coz we are wasting so many Replenisher & the Money Also

Thanks in Advance    

[tolik197]

Hello.

After plum of a cartridge not printing enter into the menu 0642 Processor I/O Check and check up a condition of gauges fs740,741 and 742, they should be in position yes. If it not so add waters in a compartment of a cartridge before gauge operation. From left to right Р1, Р2А, Р2В

[Husnain147]

Thank you very much for support

i will check.

will stopped printing start again after adding water ??

[tolik197]

Is better cancel the order for viewing of gauges, after water addition rearrange the remained photos

[Husnain147]

Thank you Very much tolik197

[tolik197]

And in what tank does not add some water???

[Christina Rose]

adding water will give a temporary solution. first check why the replenisher level senors goes to uneven level detection. it could be dirt on sensors, check replenishing rates.