George Best Posted November 1, 2010 Report Share Posted November 1, 2010 I recently re-installed the software for my Fronter 340. (Replaced a CTP24 and had to re-install). Everything is fine except the colours of the prints now... The Density looks fine but the CMY on the test print is off... Images attached below... Please let me know how i can solve this as soon as possible Quote Link to comment Share on other sites More sharing options...
PMD Posted November 1, 2010 Report Share Posted November 1, 2010 change chemical P1 and P2. ur problem will be solved. Quote Link to comment Share on other sites More sharing options...
George Best Posted November 1, 2010 Author Report Share Posted November 1, 2010 The P1 solution is new, just filled it. Maybe changing the p2 might help Quote Link to comment Share on other sites More sharing options...
George Best Posted November 1, 2010 Author Report Share Posted November 1, 2010 But the Density is ok, meaning my p1 (Developer) is fine. Probably the p2 is he problem. Any other reason why the prints look like that??? Quote Link to comment Share on other sites More sharing options...
slade Posted November 1, 2010 Report Share Posted November 1, 2010 Retained silver due to weak P2: Replace P2 Quote Link to comment Share on other sites More sharing options...
Kevbo37 Posted November 1, 2010 Report Share Posted November 1, 2010 Definitely a chemical issue. See how dark the white background is? Quote Link to comment Share on other sites More sharing options...
hassan Posted November 1, 2010 Report Share Posted November 1, 2010 its 100% the issu of P1 .ur developer is too much hard bcoz u make it new . use some starter of P1 for make solution of P1 a lil bit weak . ur problem will b solve. ur P1 solution is too much hard . Quote Link to comment Share on other sites More sharing options...
Christina Rose Posted November 3, 2010 Report Share Posted November 3, 2010 Cp49 chemical doesn't comes with separate starter. ( Tank solution has to make from Start up kits.) Quote Link to comment Share on other sites More sharing options...
imi Posted November 4, 2010 Report Share Posted November 4, 2010 i think temprature of p1 tank solution is too high and this causes burn of print ....if you fill new p1 chemical decrease the temprature -3.0 degree ....check the result .... best of luck ... Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.