tech2 Posted June 25, 2010 Report Share Posted June 25, 2010 Hi all, Can I get a second opinion off you all please? See attached file, I suspect that this image from scanned film is slipping in the carrier, probably due to worn carrier rollers, dirty rollers or the carrier tension belt that drives the rollers. Am I wrong? Thanks and regards Tech2 Quote Link to comment Share on other sites More sharing options...
Fotoservice Posted June 25, 2010 Report Share Posted June 25, 2010 Hi The pully againt the belt is adjustable, try tightening it a little. Karl at Fotoservice dot co.uk Quote Link to comment Share on other sites More sharing options...
Christina Rose Posted June 25, 2010 Report Share Posted June 25, 2010 all the negatives showing similar issues? is it showing the monitor as it is? Quote Link to comment Share on other sites More sharing options...
Fotoservice Posted June 25, 2010 Report Share Posted June 25, 2010 The monitor only shows the pre scan Quote Link to comment Share on other sites More sharing options...
tech2 Posted July 6, 2010 Author Report Share Posted July 6, 2010 Hi all, This problem has been solved. The fix is to replace all three feed rollers in the NC135Y carrier (SP2000). Not the nip rollers, the feed rollers. These rollers become worn down and the rubber deteriorates. As a result the film slips during fine scanning. Regards Tech2 Quote Link to comment Share on other sites More sharing options...
tech2 Posted July 8, 2010 Author Report Share Posted July 8, 2010 Sorry problem not solved. Still slipping. I think the timing belts are worn. Karl "Fotoservice" if I replace and tighten the two timing belts is there a good chance it will be the fix or am I p.....g into the wind? I have no associated errors just the slipping. Reprints are fine but whole films slip during fine scan resulting in the image on previous post. Thanks Tech2 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.