messythedude Posted June 6, 2010 Report Share Posted June 6, 2010 Getting an e2626 error, is there any quick fixes that can be done? I have restarted the machine twice thinking it was a bit of dirt over the sensor but the message keeps coming up. Manual says clean the hose or nozzle/ of what? nay help would be greatly appriciated. thanks. dave Quote Link to comment Share on other sites More sharing options...
shutter Posted June 6, 2010 Report Share Posted June 6, 2010 you has´nt stated what kind of minilab you are operating. since this is under "fuji" i have checked the frontier 350/370 manual. in the fix of e-2626 they mention "cleaning nozzles". The complete description mentions overheating in P1/P2. this occurs when the flow of chemistry is to low to cool the external chemistry heaters. the most common reason are clogged circulation filters. so replace the circulation/chemistry filters in P1/P2. there are no reset of the overheat thermostat. you have to turn of the printer and wait........ the nozzles mentioned are inlets to circulation pump and process tank and outlet from the subtank and circulation pump. But, all above are i vain if you are operating some other system. regards Quote Link to comment Share on other sites More sharing options...
shutter Posted June 6, 2010 Report Share Posted June 6, 2010 checked frontier 330/340 also, same error but in PS1/2 instead. the difference are that the chemistry filters are in the bottom of the tanks, more messy. regards Quote Link to comment Share on other sites More sharing options...
pietre48 Posted June 8, 2010 Report Share Posted June 8, 2010 Most common,,,,P2 heating ellement can`t get rid of its heat...... clean the inside of p2 heater(if you`r clever you can do it without draining...Good luck.P. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.