Jump to content

please help - P2 solution heating very very slowly


vaidean.radu

Recommended Posts

i'm having some problems with the temperature at P2 solution tank on the lp2000.

It stays at about 31-33 degrees. Only after a few hours it gets warmer.

I have checked the heat sensor in the P2 solution and it works fine. The contacts at heater/sensors are ok.

It wont give the comand to start the heater when it needs to.

What do you sugest i do.

Thanks,

Radu

Link to comment
Share on other sites

hello, well just to add a little on the comments.. not sure what frontier you have, but on mine, a 350, the power board has 2 SSR's that are not used on the top left corner.. you can take one of those and replace ... but i will recommend to buy new ssr's.. i bought mine from mouser electronics in the USA.. a lot cheaper than FUJI, maybe 1/10 of the price...

Also, check connecting the heater P2 to a different output, like the one for PS1/PS2 and check if the heater get's hot.. you should tell a difference when there's enough current supplied to the heater.

Hector

Link to comment
Share on other sites

  • 3 weeks later...
  • 4 weeks later...
  • 1 year later...

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
×
×
  • Create New...
DL650
DX100