Resetting Frontier 330 minilab to factory resets

[photographertunisia]

Hello again,

Concerning the problem with my Frontier 330 (yellow colour on prints) I received the following advice:

"If you are talking about yellow oreol on black and dark yellow instead of bright, it looks like you have an exceeded output of Blue laser, because your AOM driver produces a bit stronger signal than expected. If daily master balance can't help you to eliminate this, you have to calibrate your minilab from the very beginning. I suggest you to reset all the data to the factory presets and recalibrate minilab from scratch according Setup Manual."

Please can anyone tell how to do this, bearing in mind I bought the minilab second hand, and I do not have the original software - the local technician came and set it up with his own CD.

Thanks in advance.