XRITE Posted November 19, 2009 Report Share Posted November 19, 2009 A fine black line appears at random locations on the print.Sometimes 2-3 lines,sometimes many lines or at times no line at all.I have attached a scan of the defective prints.Pls any feedback or suggestions from forum are welcome. regards and thanks in advance Quote Link to comment Share on other sites More sharing options...
Guest Posted November 19, 2009 Report Share Posted November 19, 2009 Please check the Ground of the machine. Also please try to remove and re-inssert the RAM. Quote Link to comment Share on other sites More sharing options...
Winwin Posted November 20, 2009 Report Share Posted November 20, 2009 Pls check sub scan Quote Link to comment Share on other sites More sharing options...
Leticia Posted February 4, 2015 Report Share Posted February 4, 2015 Hello, I have the same problem. I do not what to do. Quote Link to comment Share on other sites More sharing options...
sanseki Posted February 5, 2015 Report Share Posted February 5, 2015 upload a test image Quote Link to comment Share on other sites More sharing options...
Minilab service Posted February 7, 2015 Report Share Posted February 7, 2015 Read this topic : http://www.minilabhelp.com/topic/23457-continuous-lines-bands-in-prints/ Fuji 7500 = Noritsu QSS3702F ( QSS3701 with capacity booster and Fuji cartridge replenishment system ) Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.