cfctony Posted August 24, 2009 Report Share Posted August 24, 2009 hi there has anyone out ther had a problem where randomly sets of prints all print completlt out of regidter and colour , ther look very andy warhol but not what you want , i am having fuji run all testts and changing boards one by one but no sucess i can print up to 1000 prints all fine then it goes and nothing has been moved or touched >>> help cheers cfctony Quote Link to comment Share on other sites More sharing options...
Christina Rose Posted August 25, 2009 Report Share Posted August 25, 2009 i face similler problem long back. we change many boards and notihngs seems workout. but finally we findout there was some loose contact in IEEE1394 cable ( LP side earth). after fix that so far no issues. i am not sure this may be the reason in your case. but just make sure earth is perfect. also adjust laser opt. temp. change laser and exposure filters if they are not good. make sure dustfree inside. C........R Quote Link to comment Share on other sites More sharing options...
Fonseca Posted August 26, 2009 Report Share Posted August 26, 2009 I face the same problem too in the past. The reason for that, is the ground wire (earth). My conclusion is that the SP and LP have to use the same ground wire. Sometimes it uses diferent conections for ground wire. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.