Jump to content

370 Master balance aim points


Bri

Recommended Posts

Hi I am some what new to the frontier but not new to the industry. I am working on a machine that was a used install and not a factory install. It seems to balancing cool. When I run the master balance and according to the machine is "in" it visualy looks alittle cyan espicaly the closer you get to the stain. I would think it should be netural all the way down the strip as a " time slope" type balance..If not and the cyan is normal at the stain end please let me know.Otherwise  Where can I find the master aim points of the machine to make sure that they are set to a netural setting. I have poked around in the se2 mode and didnt see anything. I'm sure it is password protected.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
×
×
  • Create New...
DL650
DX100