Jump to content

Film Processor FP-232 Film Sensor Error


manager
 Share

Recommended Posts

There are a few days since my Developer displays Right Lane Film Sensor Abnormal.

In Input Check the right three sensors show 0 1 0 no matter how much I disassembled and cleaned that sensors.

I checked the CTL board connector and appears OK visually, got it out and connected again also, no change.

I also discharged capacitors and reset data with MODE-SUB and Power combination. No change.

Curious, the first sensor is ok, changes from 0 to 1, but the other two remain 1 and 0 no matter what.

That suggest a cable fault somehow because the N3 temp displays 0.03Celsius after data reset until I calibrate it.

Complicated, haa?

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
 Share

×
×
  • Create New...