MOSTAFA Posted February 23, 2009 Report Share Posted February 23, 2009 HI ALL i got a frontier 370 so i tried to install c4,c5 fdi on server but i need someone inform me how set the scanner to fdi device the server is setted up fully good the scanner doesnt work it says when make pre-operational check f-di device registration faild check network connection but the network work good as my knowladge that both computers sees the others by workgroup i think there is some changes should make in the scanner i would apreciate any help mostafa Quote Link to comment Share on other sites More sharing options...
Christina Rose Posted February 23, 2009 Report Share Posted February 23, 2009 did you install C4-C5 on scanner? Quote Link to comment Share on other sites More sharing options...
MOSTAFA Posted February 24, 2009 Author Report Share Posted February 24, 2009 THNX FOR REPLAY CHRISTINA i did not but the scanner was working with such a program in the server i dont know if it was FDI or FE cause the server was in japanees lang. and it was lost because the hard disck died . now i installed FDI C4,C5 v 5.5 in new server , it was installed good and network good too and both computers sees the other (EZPC00 , FRONTEND) the error appears is (F-DI device registration faild, check network connection) how can i know the c4\c5 is installed on scanner if not how can i install it on scanner without effecting the scanner because i have no cds for the scanner or recovery i ll appriciate yous help thank you again best regards mostafa Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.