gg Posted December 14, 2008 Report Share Posted December 14, 2008 hy everybody, need help on sp3000 the errror is w4806 (focus calibration not yet perfomed ) when i try to calibrate it say failed to calibrate. the problem is i dont have the focus calibration chart would guys tell me what to? best regard gg. Quote Link to comment Share on other sites More sharing options...
gg Posted December 14, 2008 Author Report Share Posted December 14, 2008 hy guys can anyone send me the PDF sevice manual files for the scanner sp3000 frontier 355? thanks Quote Link to comment Share on other sites More sharing options...
Christina Rose Posted December 15, 2008 Report Share Posted December 15, 2008 reinstall A1 with SP3000 scanner data floppy. no other way. or else u need focusing jig chart. Quote Link to comment Share on other sites More sharing options...
gg Posted December 20, 2008 Author Report Share Posted December 20, 2008 hy guys I am messing around with my scanner sp 3000 frontier 355 i follow the instruction and upgraded A-1 software but i unfortunately don't have the B-1 software at the end of upgrading the system restart and these two messages appear (E4387 AND E4202) question is it due to the lack of B-1, or is my A-1 bad? old A-1 version 1.5 new 1.8. pls help regards Quote Link to comment Share on other sites More sharing options...
Christina Rose Posted December 20, 2008 Report Share Posted December 20, 2008 hi, the above said error may occur because of installation not done correctly. both related with GMB startup timing error. try to put recovery cd and let it make a re-install with data floppies. there is no relation between B1 standard. A1 1.8 is good stable version. regards, Baijunj Quote Link to comment Share on other sites More sharing options...
Guest Posted December 27, 2008 Report Share Posted December 27, 2008 A1 ( 1.8 ) version is almost two three years old. The newer version is 3.0 and unfortunately I'd lost my CD. Quote Link to comment Share on other sites More sharing options...
Christina Rose Posted December 27, 2008 Report Share Posted December 27, 2008 ok....thanks for the update. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.