PeterD Posted August 12, 2008 Report Share Posted August 12, 2008 Since one week I have problems with my nc100ac mask, 135mm is printing normaly, but the APS stops during scanning of the film (not yet printing) The problem so i figured, is a problem on the ctc22 circuit board. The message is E-1802, conjugate lenght variable lower limit sensor D212 failed. several options are given: Reconnect the connector, remove foreign matter (?) caught in sensor D121 and replace blown fuse (FE2) in the CTC22 circuit board. Does anybody knows where that ctc22 is lcated, so i can start to replace the the fuse if it is broken and reconnect the connector. Quote Link to comment Share on other sites More sharing options...
PeterD Posted August 13, 2008 Author Report Share Posted August 13, 2008 Anybody?? location of the circuitboard CTC22? Quote Link to comment Share on other sites More sharing options...
Christina Rose Posted August 13, 2008 Report Share Posted August 13, 2008 hi, CTC22 located in the back side of the machine, inside the image processing section...for removing CTC22, need to open the rear cover and then open image processing section..inside you can see that CTC22 PCB. regards, baiju. Quote Link to comment Share on other sites More sharing options...
PeterD Posted August 13, 2008 Author Report Share Posted August 13, 2008 Thanks again. Quote Link to comment Share on other sites More sharing options...
PeterD Posted August 21, 2008 Author Report Share Posted August 21, 2008 8) 8)It is working again. The fuse was not broken, but reconnecting the connector on the circuitboard CTC22 did it. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.