tango Posted September 7, 2006 Report Share Posted September 7, 2006 Hi everyone, has anybody had this problem before on frontier 350. Today suddenly, the scan desk saids commulaction error between the scan desk & printer, on the middle of sending digital files through to printer then just stop, I had to re boot the scan desk then it see each other again, but then error comes up again, I check the fire wire between them, on scan desk seem good fit, but on printer side, on the little board seem's ok or has a very little movment on connection, the fire wire cable seem very good. any one had any suggestion. thanks Guys. Tango Quote Link to comment Share on other sites More sharing options...
impressive_cba Posted December 29, 2007 Report Share Posted December 29, 2007 please download software all of scanners or try installing softwares of scanner section your windosw nt got currepted. and first shut down machine for 30 minutes and start it again.and also check all the fans are working properly.and everthing is ok on boards behine the scanner Quote Link to comment Share on other sites More sharing options...
citytec Posted January 2, 2008 Report Share Posted January 2, 2008 Dear friend Your frontier a um problem with the pcb gmc 20. Quote Link to comment Share on other sites More sharing options...
nash Posted January 3, 2008 Report Share Posted January 3, 2008 Dear Tango i`m afraid citytec is right i had the same problem i called in CMS ENGINEERING it cost be nearly Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.