Jump to content

rack drive cogs wearing


Kelvinprint
 Share

Recommended Posts

Hi Can someboby help me

Replaced rack drive cogs,shaft and bearings on a dks 1515 ran a film threw it and the cogs had worn. Dev, BX and No1 Stab. racks are fine not stiff spring tentioner at its lowest worm gears replaced. Drive shaft not bent.

Could heater be the problem as prints are hot

many Thanks

Link to comment
Share on other sites

Cogs would be gears.  The problem is probably in the tank heater thermostat circuit. Photo Me, and KIS has an old history of problems with this, although I thought it was gone long ago! Check the temperature of the bath(s) against specs, this may lead you in the right direction.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
 Share

×
×
  • Create New...