aminusaminek Posted April 5, 2012 Report Share Posted April 5, 2012 hi i have this probleme what i do? Quote Link to comment Share on other sites More sharing options...
aminusaminek Posted April 6, 2012 Author Report Share Posted April 6, 2012 please help Quote Link to comment Share on other sites More sharing options...
pskaro Posted April 6, 2012 Report Share Posted April 6, 2012 TFT card problem ? Polariser test is done selecting only Red box and the difference should be more then 300, usually the best I could get was 350. If you have only 0 then try to change the TFT PCB, but it is very complicated to adjust it to have good LUT without expirienced technitian Quote Link to comment Share on other sites More sharing options...
aminusaminek Posted April 7, 2012 Author Report Share Posted April 7, 2012 thanks, but i change ravage carte and my lcd and impag card and cicclone card and interface card, the same probleme Quote Link to comment Share on other sites More sharing options...
pskaro Posted April 7, 2012 Report Share Posted April 7, 2012 Did you also changed the cable between the Ravage and Ciclone PCB ? Have you checked the filter motor and the lamp ? After all off this only what is left is meausuring cell in the middle off the exposure deck, but you could test it with stability test and open cover, you should get some readings. Also check the input voltages on Ravage PCB. Quote Link to comment Share on other sites More sharing options...
aminusaminek Posted April 7, 2012 Author Report Share Posted April 7, 2012 yes i change cable and motor and lamp, they stay only the meausuring cell, the teste stay on 0, and thanks Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.