RikiRiki Posted November 4, 2011 Report Share Posted November 4, 2011 HI, My Dks 1610 don´t take the paper, when I mount the paper it make a diferent sound and dont take the paper. I had reinstaled sofware and take a look in the cutter but I had seen nothing. Can somebody help me? Thanks Regards from Spain pd, sorry my English is not so good Quote Link to comment Share on other sites More sharing options...
RikiRiki Posted November 4, 2011 Author Report Share Posted November 4, 2011 Do you know if could be the engine of cutter,??? Quote Link to comment Share on other sites More sharing options...
RikiRiki Posted November 5, 2011 Author Report Share Posted November 5, 2011 The cutter go up when I star the machine, move the paper but don´t cut and failed Quote Link to comment Share on other sites More sharing options...
poorkid Posted November 7, 2011 Report Share Posted November 7, 2011 it think is't the cutter can board,or the mounting problem. Quote Link to comment Share on other sites More sharing options...
pskaro Posted November 7, 2011 Report Share Posted November 7, 2011 Check two microswithes for knife position inside the cutter, I had one situation that one off the microswithes was malfunctioned, and I exchange it for the cassette door microswitch as a first aid Quote Link to comment Share on other sites More sharing options...
RikiRiki Posted November 7, 2011 Author Report Share Posted November 7, 2011 OK, Thanks the other day a saw these two microswithes, if i changed the cable position I can see if one of them is broken and is a good idea use the door withes Quote Link to comment Share on other sites More sharing options...
pskaro Posted November 7, 2011 Report Share Posted November 7, 2011 Or you can measure it with ohmmeter, but you have to disassemble it from its position to do that Quote Link to comment Share on other sites More sharing options...
RikiRiki Posted November 12, 2011 Author Report Share Posted November 12, 2011 Buff!! I saw all but the cutter don´t work, the microswithes are in good condition. you know your position if the cutter is open or close. If the cutter is close the down microswithes is into the plastic circle???? Quote Link to comment Share on other sites More sharing options...
pskaro Posted November 12, 2011 Report Share Posted November 12, 2011 But have you measured it with the instrument ? There is also diganostic application to check its work, but that is for technitian only Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.