Jump to content

print not uniform


DKHECHI MED
 Share

Recommended Posts

I had a problem similar to that along with staining. Never found out the reason why - just solved it by dumping chemistry and cleaning racks. I think it was probably the bleach. I also replaced  the turbines so the tanks have a good mixing flow of the chemistry. I also replaced any bushings that were worn in the dev and bleach. The idea being that the spacing between rollers is accurate so they can remove the chemistry from the print  a little better before it goes into the next tank.   Ronnie

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
 Share

×
×
  • Create New...