Jump to content

Paper feed problem


askey
 Share

Recommended Posts

on our 1510 when paper roll gets down to last 30mtrs or so we are getting white edges on leading edge of prints.It would apeear that this is down to the curl on the paper and not the tightness of the roll. I have changed the paper cutter but still getting whiite edges, as anyone else had this problem and has anyone a solution .

Link to comment
Share on other sites

  • 2 weeks later...

Hallo.  On the exposure deck there are two paper detection sensors.  In the middel of the exposure deck there is sensor for the light source(about 5mm x 5mm), about 4 - 5cm from that sensor (at about 2 o'clock and 4 o'clock) inside the small wholes of the paperdeck there is 2 very small black sensor which tells the machine where to stop the paper for exposure.  Take a flashlight and look for them and the clean then, dust on these sensor causes paper to have whiteborder on the short side of a 4x6 print.

Hope this helps....

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
 Share

×
×
  • Create New...