Jump to content

where abouts is bx heater located on Dlab 3??


nixphotopix
 Share

Recommended Posts

does anyone know where the bx (bleach/fixer) heater is located on the Dlab 3? We have tracked down the sensor and cleaned that but need to find the heater now to check for a problems. It is heating up but extremely slowly and cannot get to optimum temp for long (38deg C) when it gets to this temp it normally drops to about 36.6deg. but still prints without any probs, is this normal? Is 38deg correct value?

Cheers.

Nick

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
 Share

×
×
  • Create New...