Jump to content

agfa dlab-3 laser problem


maxifoto.mladen
 Share

Recommended Posts

Hello everyone. I own AGFU DLAB-3 and before 3 months when she began to start eliminates mistakes PR: POWER / PAPER GAIN VALUE BLUE can not be SET, PAPER calibration. After warming chemistry machine and reset it all the time down to work normally. I talked with the service that  set the machine and they say it is a small thing, because a laser is still new (2500 hours) FLR was serviced 15 months ago and AOM are very good condition and that it is a consequence of temperature changes in store. Is the bass and what I hope? Thanks in advance for your help.

PS: Since do not know enough English language I used a site that has a Dictionary of the English translation of my message. I hope you understand what I wanted to say.

Link to comment
Share on other sites

First the laser power is higher than it should be .

Then ,on the cover Of the FLR there are three values was written by hand for red,green,blue.

this value should be the same in the setup value ,to chech, go to the service.

scripts for service/printer/laser/monitordiode_gain_setup.txt

Link to comment
Share on other sites

  • 2 weeks later...

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
 Share

×
×
  • Create New...