Jump to content

Dlab2 Gas Laser Allignment


Cmarts1

Recommended Posts

Take off the black cover and pull the door interlock,enter service mode and run the fibre_adjust script.

loosen the two locking screws a quarter of a turn abd watch the dynamic readout. don't move the alignment adjusters just yet but hold the back end of the coupling and move it around a little to see if you can get the power reading to go up. If you can get it to increase remember how you moved it and move the adjuster in the same way in little steps to maximize the readout. when you have the maxiimum reading quit out and run again.(that is important). Then you need to to a pbl with laser point on your main paper. The one with the M

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
×
×
  • Create New...