Jump to content

DLab 2 Gas Laser Does Not Ignite


Cmarts1

Recommended Posts

Hi there

Yesterday we had a few problems with our DLAB2 we were printing then on a reset

we heard a bang from around the printer power supply area. The main trip blew at

the other end of the machine but on reset the laser will not ignite.... The LED

on the power supply board for the laser is not lit. Could this be a problem with

a fuse ??? or do we need a new laser?????

Any help would be appreciated.

Many Thanks

Link to comment
Share on other sites

Hi there

We have been reading our service manual for the DLAB2 and have come across a

couple of things to try in the service menus to check the lasermodule....

We have run the following script and wonder if anyone could tell us what the

results tell us about the laser module... Any help would be greatly

appreciated....

Scripts for service\Printer\Laser\quick_check_lasermodule.txt

Results.

PRINT: MONITOR DIODE 1(NEW)

PRINT: MONITOR-DIODE GAIN: +00654®, +01277(G), +01023(B)

PRINT: MINIMUM AMPLIFIER VALUE: RED=0000, GREEN=0000, BLUE=0000

PRINT:SETUP_VALUES...

PRINT: MONITOR DIODE RED :+00654, GREEN: +01277, BLUE: +01023

PRINT: NOMINAL COLTAGE RED: +01057

PRINT: MONITOR DIODES: (1) CALIBRATED

PRINT:

PRINT: WAIT FOR POLIFILTER CHECK - - - - ANSWERTIMEOUT (90000MSECS) FOR PR

RDLAVPAP$2!3!$3!!!"

Hope that it makes sense, we ran this script a couple of times and the same

thing happened.

Many Thanks

Link to comment
Share on other sites

Hi there

I wonder if anyone could tell us the main difference between the Argon Gas

Lasers and the SSL Lasers its looking more and more likely that we need a new

laser and are debating which would be better for us.... Which would be easier to

fit, which would be more economical to buy and which one would work with our

machine......

Many Thanks for anyhelp in advanced.

Link to comment
Share on other sites

HI

difference between the Argon Gas Lasers and the SSL Lasers

  SSL IS better IT UNLIMTED After long time you  will change FLR only

to change from Gse to SSL

  1- power suplay FOR laser

  2- control (G)

  3- control (B)

  4-   FLR

  5- (PCB) Power monitur

  withe the same Softwaer

Bestregards

osama

do change

Link to comment
Share on other sites

If you heard a bang from the power supply it has gone bad. It might be caused by a laser but sometimes the power supplies just die. Can you tell me the manufacurer of the power supply? If it is a Laser Drive Inc. or has a Lasos name on it, they are prone to fail with a bang like that. I can provide a new supply of a better design and check out and repair your laser for you.

Contact me at:

Kevin Waller

National Laser Co.

kwaller@nationallaser.com

801-467-3391

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
×
×
  • Create New...