Jump to content

Problem 740 Masterlab


LJ

Recommended Posts

I have a problem with Gretag 740 masterlab. Changed the paper drive motor and after that one of the boards in wetpart control section burnt. It was the 803 board. Four transistors( I think) burnt completely. Put a new  

board in and after a minute those four transistors was so hot I could not touch them, then turned machine off quickly. Not sure what is causing it, any help would be appreciated.

Than you

LJ (South Africa) :o

Link to comment
Share on other sites

  • 1 month later...

there might be wires on your new motor that go from positive and neg leads to ground on the motor frame. On older masterlab non + models the wires on new motors would fry the 803 causing the sorter to not work. Cut the wires and tape the ends so they wont arc on anything and you should be done blowing 803's. Good luck 8)

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
×
×
  • Create New...