logonoa Posted September 28, 2007 Report Share Posted September 28, 2007 Dear All, The problem with my Gretag Masterlab +740 machine is that, when I order prints, the paper comes out white(blank). I tried to open the front part of the machine to see what is wrong during printing, what I found out is that, the light strikes(reaches) paper deck first before the paper is properly placed on light path; the paper misses light exposure from the film deck. When I did "test print" I got blue(normal) prints. After sometime, an error message appeared "Attenuator not detected" The Gretag manual" says make sure attenuator is functional,I tried to fixed the problem, but still it persists. Please your help is needed. Alex Quote Link to comment Share on other sites More sharing options...
Martyn Posted October 1, 2007 Report Share Posted October 1, 2007 Hi Alex, The Attenuator is only used on a very short exposure, you also say that the test print is OK. but it should be grey not blue. I would therefore recommend you reset the Master & Paper Channels back to default (As per the manual) and re-test until the result has passed. Good luck..... 8) Quote Link to comment Share on other sites More sharing options...
Sait Terekli Posted November 17, 2008 Report Share Posted November 17, 2008 Hi Alex, Did you try to test shutter!! Maybe shutter motor or its board is out of order. Sait Terekli, istanbul Quote Link to comment Share on other sites More sharing options...
Mohamed Koroma Posted December 8, 2013 Report Share Posted December 8, 2013 hallo.plise am looking for all instulation softwere for my masterlab 740+.Can u plise help me?thanks Quote Link to comment Share on other sites More sharing options...
Sait Terekli Posted December 9, 2013 Report Share Posted December 9, 2013 Dear koroma, i have some software, please let me know which software are you looking for? it is printed on ICs. i copy and send to you software. They are about 8-9 pieces on minilab. write me detail info to my mail. saitterekli@hotmail.com Quote Link to comment Share on other sites More sharing options...
Mohamed Koroma Posted December 18, 2013 Report Share Posted December 18, 2013 Dear All, The problem with my Gretag Masterlab +740 machine is that, when I order prints, the paper comes out white(blank). I tried to open the front part of the machine to see what is wrong during printing, what I found out is that, the light strikes(reaches) paper deck first before the paper is properly placed on light path; the paper misses light exposure from the film deck. When I did "test print" I got blue(normal) prints. After sometime, an error message appeared "Attenuator not detected" The Gretag manual" says make sure attenuator is functional,I tried to fixed the problem, but still it persists. Please your help is needed. Alex Hallo, can u plise contact me on this Email. alie_koroma_@hotmail.com. thanks. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.