mikes Posted September 3, 2007 Report Share Posted September 3, 2007 My ADM on my 740+ is displaying error code 59 and 58 ( Not ready, please remove strip) even though there is nothing in the ADM. Have taken the unit out and cleaned it out thoroughly but still get the errors. Have checked the cable to CBO2 - seems ok. ANY IDEAS?? Mike Quote Link to comment Share on other sites More sharing options...
Tote2008 Posted March 14, 2008 Report Share Posted March 14, 2008 Hello, sorry my english.You must open ADM.The problem could be a sensor at the right ,inside a wheel with holes.Blow with air this sensor before end check.It is very common this sensor failure and will changed it.good luck! Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.