Jump to content

DDP411 help


Lankey

Recommended Posts

Hi all,

I am having a problem with my DDP-411 noritsu machine, I keep getting cut mark sensor errors, it appears to be after 5 or 6 prints (using one roll or 10/12 prints if using 2 rolls) and then stops with afore mentioned error. I have tried cleaning sensors, adjusting a couple of the pot resistors  on the circuit board on the cutting mechanism as someone had suggested, I have tried adjusting in the software the cut position correction setting which moves the cut mark about abit but still get the error but I could be doing something wrong with this process as I have never needed to do it before.

Has anyone come across this before or have any suggestions?

or alternatively does anyone have the service manual available?

thanks in advance

Steve

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
×
×
  • Create New...