enwan moses Posted June 25, 2012 Report Share Posted June 25, 2012 Hello all,please can anyone help us solve this problems, big yellow lines on prints,this line comes on some prints while others are ok.morning set up/weekly set are ok. Attached are affected prints and setup results. Thank you. Quote Link to comment Share on other sites More sharing options...
PHOTOLABPART.COM Posted June 25, 2012 Report Share Posted June 25, 2012 Dear Sir Interchange Aom and Check if color is a change from green to blue its AOM problem If you need any parts for 3001 please contact us minilabtechn@gmail.com Quote Link to comment Share on other sites More sharing options...
yustas Posted June 25, 2012 Report Share Posted June 25, 2012 Hello Enwan, The most probable cause of it is defective blue laser module (weak) or AOM crystal unit (located inside the laser unit). Please read our web site and perhaps it will help you to find right solution of this issue. http://www.minilablaser.com Quote Link to comment Share on other sites More sharing options...
enwan moses Posted June 29, 2012 Author Report Share Posted June 29, 2012 Hi minilabtechnician,thanks a lot for your advice,it was defective green AOM,we had spare we change and is working fine now.my warm greetings to you and all contributors in the forum,best regards. Enwan Moses Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.