Jump to content

Recommended Posts

Could be something else if your prints aren't overlapping, but my first suspicion would be cross over No-3 and rack-2  (Bleach). Drive gears on the cross over are prone to build up of crystals and the gears, this tends to bog down and load up the drive to the crossover. The double grey idler gear can also sieze on the shaft eventually if it gets pitted too much.  Check the larger grey idler gear on the rack which drives the crossover. Same as above, gets encrusted with bleach crystals, Idler gear  hole gets  enlarged and rocks on the pin, also gets pitted and needs to be replaced at some time. Gears on this  cross over need to be washed and scrubbed every second day at least if you are turning over a fair bit of work.

While you've got the rack out, check the lower turn belt is not too loose.

Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
×
×
  • Create New...