mmm1962 Posted May 30, 2011 Report Posted May 30, 2011 ez controller has crashed and reverted back to original set up before any channels were imput,wher can i find the back up path file to read from.
photocorp Posted May 30, 2011 Report Posted May 30, 2011 Daily back-up data is saved to : C:\Noritsukoki\DailyBkData You can configure the destination path for this data to write to a USB Flashdrive or any other media, that way you have another convenient source for recovery data. From the Service Manual, all is explained here.......
photocorp Posted May 30, 2011 Report Posted May 30, 2011 FYI A bit more on backup data. The EZ Controller writes to the local drive© by default, that's all very well until the Hard Drive fails! so what then, you can't recover data as that's all disappeared into cyberspace along with your blank screen and blinking cursor....... Size of data for backup is around 6.5~7.0mb, so if your Noritsu is part of a Workgroup then point the destination path to a folder in your stand alone destop PC, or reserve a USB flash drive just for this specific purpose. This is cheap insurance and saves on a lot of anguish and labour by not having to reconfigure your basic setup and print channels all over again. We physically clone our lab HD's so in the event of a major catstrophe, it's plug-n-pray, power on and away you go. The EZ Controller PC has two HD's, you could write the data this drive (E). Drive is used as a Nk workflow and order management database processing "buffer" and does not contain the OS, however there is a hand shake with the main system software so one won't function without the other. Basically it is just storage.
Magenta Posted May 31, 2011 Report Posted May 31, 2011 EZ controller is a pain if you change IP address or Printer name it tells you that channel data will be reset, I had someone loose the lot as he renamed the printer the same name as as his dog ;D
photocorp Posted June 1, 2011 Report Posted June 1, 2011 Bump PM from Ammm1962 "okay got all channels back ,only problem now is it says file not recognised when try to print from c drive or any other media. Any advice." Anyone else like to weigh in here with some words of wisdom.
Freddy Martinez Posted January 26, 2020 Report Posted January 26, 2020 On 5/30/2011 at 4:51 PM, photocorp said: FYI A bit more on backup data. The EZ Controller writes to the local drive© by default, that's all very well until the Hard Drive fails! so what then, you can't recover data as that's all disappeared into cyberspace along with your blank screen and blinking cursor....... Size of data for backup is around 6.5~7.0mb, so if your Noritsu is part of a Workgroup then point the destination path to a folder in your stand alone destop PC, or reserve a USB flash drive just for this specific purpose. This is cheap insurance and saves on a lot of anguish and labour by not having to reconfigure your basic setup and print channels all over again. We physically clone our lab HD's so in the event of a major catstrophe, it's plug-n-pray, power on and away you go. The EZ Controller PC has two HD's, you could write the data this drive (E). Drive is used as a Nk workflow and order management database processing "buffer" and does not contain the OS, however there is a hand shake with the main system software so one won't function without the other. Basically it is just storage. You think I can get the help setting up Ez controller, I have all the disk but I am stuck ready the backup Data and print Head.
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now