purnomosetiawan Posted March 11, 2011 Report Posted March 11, 2011 guys i have prob;em with my minilab, when i do paper set up or daily setup, sometimes paper is slip when entering densitometer, so the set up is failed. Sometimes after some measurement the paper just gone through fast and (again) set up is failed because measurement is not finnish. is it sensor problem related ? Thank you for you help
Fingerz602 Posted March 11, 2011 Report Posted March 11, 2011 you might need a new colorimeter but you can try cleaning the wheels with a cleaning sheet.
bostanxhi Posted March 25, 2011 Report Posted March 25, 2011 hello. i have one problem. with my noritsu 3501. when i print picture. the yellow lights in desktop (simbol of pictures. dont are sincronizet with picteures. haw can sincronizet it. and have error. paper jem in printer. when picture are out. plese help me?
Langson Posted March 25, 2011 Report Posted March 25, 2011 THE SENSORS ARE OUT OF ORDER, IT MAY BE ONE OR BOTH SENSORS BLOWN, THEY ARE TWO SENSORS FOUND TA WHERE PHOTOS COMES OUT FROM JUST AFTER THE DRYER, ITS ACTUARY THE LAST PART OF PROCESSING. CHECK THOSE SENSORS. LANGSON
Langson Posted March 25, 2011 Report Posted March 25, 2011 ACTUALY THIS PROBLEM IS BECOMING VERY COMON WITH THE 3501, THE ISUE IS WTH SENSORS JUST CHEK THEM AND YOU LL BE DONE, I WAS JUST FIXING THE SAME PROBLEM TWO DAY AGO. LANGSON
bostanxhi Posted March 27, 2011 Report Posted March 27, 2011 Hi Langson.. I tried but I could not repair,, please help me how can i repari ti... i cleaned the sensor in dry but it have again problem,,, i exekute... i can run it in servis mode but all execute for sensor have given no... I am very grateful to you,,, for help.. best regards
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now