Jump to content

Recommended Posts

Posted

hello,

i have brown lines on all of my print, different size, different paper. Even on the daily setup. I put a black tape on the laser head and the print are correctly white. What shouid i check

Best regards

vic

Posted

Vincent.

Could very well be banding in the exposure advance unit as mentioned above, but you won't see that on white prints (or black either obviously). We need test prints or work production samples  to confirm if problem lies in paper process or Laser section.

To better diagnose your problems,  any chance you could scan an image of the print and post here. Show the direction of paper.

Posted

here's the pic. I already check the printer section, the roller looks ok. The first signs of my problem begins with 1 or 2 litlle thin brown line. And now all my print are plenty of line.

i will post my daily setup

thanks

Posted

This problem is caused either by a failing blue AOM driver, or the blue laser gun is getting tired/weak.

Underneath the last paper advance unit (just before the paper goes into the developer tank) there are 3 silver boxes, these are the AOM drivers for each laser.

Mark each AOM driver so you know where they came from. Now swap the AOM driver from the red to the blue position and see what happens.

If you now get red/ blue lines on the print or error 6073 the red AOM driver (swapped from the blue position) will be faulty and will have to be replaced.

If the problem goes away, chances are the blue laser is on it's way out, meaning your laser unit will have to be repaired.

Posted

Hello Vincent,

Yes, sorry to inform you but I am afraid that you will need to repair your blue laser ' gun' if AOM-drivers swapping will not help to find the problem (exclude faulty AOM driver)...

Please read how to swap them at our web-site:

www.minilablaser.com

Note:

This laser issue has been already described a lot of times on this forum threads.

Please use Search to find it and get the solution.

P.S.

We have fast and cheap way of laser repair for you.

Send inquire.

Posted

Vincent, follow the advice of the people who suggest to swap the AOM drivers. this is actually very simple and is the most common trouble shooting procedure to determine if your problem is a laser or an AOM driver.

I suspect as Yustas that is is a laser problem. But a few minutes swapping a few pieces will answer the question.

Posted

I dont think that the problem is with the AOM. With a bad AOM I think you will get more of a color change on the full print. I think your problem is with the laser itself or the laser IO PCB. Do a Laser Diagnostics test first.

Posted

hello

you mean testing by the soft called "laser self diagnostic" ?

I am going to switch the AOM to be sure that he problem is loctaed in the laser unit

thanks

Posted

Vincent,

The problem could also be one one the driver boards on top of the laser for the blue and green. You can swap the board around and see it the problem changes. I would check that before I would change the laser. Let us know what you find out.

Posted

If swapping the AOM drivers did not help, the most likely problem will be the laser unit itself is worn out, especially given the age of your laser unit.

Posted

Dear vincent,

We launched new way of service (in trial mode) and can help you to save a lot of money on your laser unit repair.

Please read our offer in Private Message section.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...