Foto Brouwer Posted December 13, 2010 Report Posted December 13, 2010 Hello we have transported our Noritsu QSS 3211 to another shop of us, after installing the machine, we booted up ending with this 2 errors: 6901-1008 Arcnet comminucation Error 6901-2008 D-ICE Control PCB I've checked the troubleshooting manual, and i noticed that there must something be wrong with the fibre optic cables, i've checked and cleaned them, but the error still occurs, and it's preventing booting up the software. I tried to reinstall the LVDS/Arcnet driver, didn't work either. Maybe there are some other things i could try? Thanks in advance! Marcel Wey Foto Brouwer , The netherlands
frenchman Posted December 13, 2010 Report Posted December 13, 2010 Hi,Foto Brouwer, Clean with a vaccum cleaner the hole for the optical fiber(in the deck section! ) ,maybe with the transportation the hole's for the fiber are full of durst !!! Regards frenchman NEVER USE Bomb(Spray) with area in this location !!!!!!!!!!
Minilab service Posted December 20, 2010 Report Posted December 20, 2010 Hi.The first check is Arcnet properly connected ( transmitter to receiver and receiver to transmitter ) . If it is - try to clean. If it will not help you will have to exchange transmitter and receiver in LVDS/Arcnet board ( Caution! Board has few layers, so soldering have to make advanced technician !!! In any case you can destroy pcb. ) . By the way in few minilabs I exchanged all transmitters and receivers and after that minilab owners noticed that minilabs started to work faster, than with old transmitters and receivers. Arcnet errors disappeared.
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now