Dotun Posted June 11, 2010 Report Posted June 11, 2010 hi minilabhelp my noritsu 3300 is writting motor stopped and error no 5550 i need help
Guest Posted June 11, 2010 Report Posted June 11, 2010 check Fuse F61 on sub relay PCB (J391273) or Motor itself. or processor Control PCB or Processor Power supply.
Dave S Posted May 8, 2020 Report Posted May 8, 2020 (edited) Check the drive belt on the drive motor hasn't come off or snapped. Check the bearings on the drive shaft are not seized up. Edited May 8, 2020 by Dave S
Minilab service Posted July 4, 2023 Report Posted July 4, 2023 J390935 is sub relay PCB on QSS33xx . Fuse F61 is on this board. Check do you have 24V power supply on J/P658 ( between pin 1 and pin 3 ) . If you have it then your motor should have power supply. Motor control signals come from processor control pcb.
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now