Jump to content

2711 dls bad gamma prints


foxglove
 Share

Recommended Posts

Foxglove,

I had a problem on my QSS 2711 DLS where the prints were fine to start with print fine until the machine was idle and then give either yellow prints or prints that look like your. I found that the power supplied located on the rack under the paper transport #1 unit was full of dust and was over heating.

Please try to take them out, please note that on the rack that slides out from under the machine @ the exposure door section has 3 or 4, power supplies on not just the 2 in front. It is a big job to take them out and clean them. It is best if you have a technical friend to help you take the rack out. It took me approx 3 hours out, clean and in. After that set up.

I hope this helps.

Link to comment
Share on other sites

  • 4 weeks later...

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
 Share

×
×
  • Create New...