Jump to content

QSS 2611 6019 Error


Antic

Recommended Posts

Sounds like you have a lift problem. Check there is no paper in the lift section, slide whole unit out and check everything moves freely (but not too freely!).

When moving lifts, use the belts NOT the components, and treat it with respect, they are expensive.

This error is usualy displayed after a dropped print or similar error.

If there is nothing out of place or obviously wrong, re-start (put m/c into hibernation, close breaker, turn off supply, wait 4/5 mins, turn on supply, turn on breaker, m/c will initialise) If it is a calibration problem with the lifts that the initialisation cannot sort out, you need an engineer or help from this forum .

Good luck

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
×
×
  • Create New...