ckphoto Posted May 27, 2008 Report Posted May 27, 2008 Hello, I am getting a green line on some of my prints all sizes. I was experiencing the same problem about a month ago but it was a bad fan for the image processing PCB board I replaced it and all seemed well until this past week. I put a small fan outside the intake but still get the line. Thanks-
Guest Posted May 29, 2008 Report Posted May 29, 2008 Are you getting Green Lines on both digital and negative prints?
Jvc1986 Posted May 30, 2008 Report Posted May 30, 2008 Check the uniformity "reader" for dust, it sits on the mlva head cleaner unit, you can see it if you run a Brush Cleaning, then look at the right side of the "socket" for the brush, you'll see a little hole with a optical reader inside, try to clean it with compressed air and do a uniformity setup, it may help, but not sure if this happens to all paper (if you have different types)
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now